10BD1

10BD1

 

Model 10BD1 Satellite Slave Card

For a standard “B sized” mainframe to integrated into a  System 10 network that is is equipped with a Model 10BD4, the remote “B” mainframes must contain a Model 10BD1 Satellite Slave Card. This card can be placed into any unused “B” slot within the mainframe and communicates in a transparent mode with the host and other satellite units within the network to maintain the 2500 channel per second system update rate.

10BCP200

10BCP200

 

Model 10BCP200 Central Processor Card for "B" Mainframes

which replaced the Model 10BCP100, A, L, R version, is the primary processor card for the “B” size System 10 Mainframes and comes standard in a System 10 “B” size mainframe when ordered. It is the removable processor card which contains the system configuration memory, processor data, and operating firmware circuitry to manage the System 10’s scanning, communications and A/D processes.

10BACI-488

10BACI-488

 

Model 10BACI-488 Auxillary Computer Interface Card  IEEE-488

is equivalent to a Model 10BACIA with a 24-pin parallel port for standard TALKER/LISTENER communications with an IEEE-488 bus (in place of the 10BACIA's standard RS232 interface).

10BACI-422

10BACI-422

 

Model 10BACI-422 Auxillary Computer Interface Card RS-422

is equivalent to a Model 10BACIA with an integral RS422 hardware interface on a 9-pin subminiature female socket (in place of the 10BACIA's standard RS232 interface).

10BACIA

10BACIA

 

Model 10BACIA Auxillary Computer Interace Card

This card permits any System 10 "B-sized" mainframe to establish simultaneous high-speed communications with more than one external RS232 device (computer, terminal, buffered printer, recorder, etc.).

Each 10BACIA supplies an independent "auxiliary" full-duplex RS232 interface, operating with its own user-specified "protocol" characteristics.  The number of 10BACIA cards a mainframe may contain is limited only by the number of available "B Slots".

10AST

10AST

 

Model 10AST  "A" Slot Test Card

is a special diagnostic and service tool.  Plugging into the Slot Connector of any mainframe "A Slot," its front section protrudes from the slot.  Through an array of labeled terminal posts, it thus allows voltmeter or oscilloscope observation of power and reference voltages, logic and calibration signals, data-bus lines, and all other signals pertinent to the slot in question.

10AHM

10AHM

 

Model 10AHM Health Monitor Card

Installed in any unoccupied System 10 "A Slot," this card lets the system read and display all pertinent power and reference voltages.  It has its own independent temperature-stabilized reference source to verify the accuracy of all measurements.

10AEX-20

10AEX-20

 

Model 10AEX-20 "A" Card Test Externder Board

lets you operate any System 10 "A Card" outside its designated "A Slot." It thus permits direct access to all of the card's "on-board" hardware, while at the same time maintaining any and all of the card's rear connections (to transducer, contact closures, other system cards, etc.).  The Extender Board may thus be used for purposes of signal tracing, waveform observation, adjustment of internal controls, card calibration or various other diagnostic or service functions.

10ACP200

10ACP200

 

Model 10ACP200  "A" Main Processor Card

The 10ACP200, which replaced the Model 10ACP100, is the primary processor card for the “A” size System 10 Mainframes and comes standard in a System 10K1C or 10K2D mainframe when ordered. It is the removable processor card which contains the system configuration memory, processor data, and operating firmware circuitry to manage the System 10’s scanning, communications and A/D processes.

10ACC-4

10ACC-4

 

Model 10ACC-4 Four Channel Totalizer Card

provides the totalizer (counter) function, like the  Model 10ACT01 Counter/Timer input function for up to four individual TTL-level inputs (+ 5 VDC, maximum; contact closures are negative true to ground).  It is particularly useful in assembly-line applications that require the accurate counting of large numbers of parts.

Pages

Subscribe to RSS - Specialty Cards
 
 
 

Help us serve you better!

Daytronic strives to continue serving customers in the best way possible. Help us improve your experience by taking a simple survey. Please choose the correct survey and take a few moments to complete it. Thank you!

Existing Customers New Customers ×